Answer by DonDon for Extruder stops printing before finishing first layer...
Check your retraction and run some experiments with it. I just had a very similar problem, when I switched from 0.6 mm retraction to 0.8 mm filament tended to get stuck between rolers and the cooler on...
View ArticleAnswer by user995551 for Extruder stops printing before finishing first layer...
Okay, so after yet another frustrating night of troubleshooting. I believe I have identified the specific problem. I reduced the G-code file to about 100 lines of code, that 100% reproduced the issue...
View ArticleExtruder stops printing before finishing first layer (Ender 3 v2 w/BIQU H2)
Let me preface this with me being quite a newbie to 3D printing, however, I am an engineer and coder, so tinkering with stuff like this is quite the norm for me. Don't be afraid to be too technical,...
View Article
More Pages to Explore .....
